How to install the light belt? What are the installation steps? What should I pay attention to?

Connection of light strip
I don't know if you have seen the light belt. According to our requirements, there are various sizes of light strips. For example, a plate of light strips may reach tens of meters, but there are also 1m and 2m short ones, so the specific connection of the light strips installed in our home should be determined first. For example, the light strips installed in our ceiling are basically installed with rows of light strips. Therefore, the following steps should be followed to determine the connection of the light strip.
① Determine the length of the light strip to be installed, and then take an integer according to the installation length. Like our common light belt, it is about a unit of 1m, so we should ensure that this unit will not be damaged when intercepting. In this way, it is required to cut it from the cut, so as not to affect the circuit. If we arbitrarily intercept it, some of the lamp beads may not be lit. Therefore, the first step is to determine the length and then intercept.
② , fixed. Since the light belt used in our home is not waterproof, because the light belt is installed in our ceiling groove, the installation method is very simple. For example, most of our common LED light belts have self-adhesive tapes on their backs. We can use its self-adhesive tape to directly paste it into the groove.
③ Connection of light belt. After we use self-adhesive adhesive to paste the light belt into the groove of our ceiling, we can connect the light belt at this time. If we are worried about the movement of the light belt, we can take some double-sided adhesive tape to fix it. Finally, press it flat and fix it. At this time, we need to connect the light belt. Like LED light belt, it is a circuit structure composed of three LEDs in series or in parallel, so we can directly disconnect these parts. If there is a joint in the middle, it must be connected by special soldering method. However, try to avoid this situation, and try to use the whole section of light belt for installation.